Find your setup

Amps to Watts Calculator

DC: Watts = Volts × Amps. Single-phase AC: Watts = Volts × Amps × PF.

For example, 20A at 240V is 4,800W at PF = 1, or 3,840W at PF = 0.8, for a single-phase load. Balanced three-phase AC uses a different formula, shown below.

Updated · Calculated examples; sources and assumptions below.

Your numbers, clearly calculated

For balanced three-phase AC, enter line-to-line voltage and line current. DC ignores power factor.

Real power1,200 W

Common conversions

Real input watts for single-phase AC at PF = 1, using voltage across the load. The same numbers apply to DC, where PF does not apply.
CurrentWatts at 120VWatts at 208VWatts at 240V
2.5A300W520W600W
5A600W1,040W1,200W
10A1,200W2,080W2,400W
15A1,800W3,120W3,600W
20A2,400W4,160W4,800W
30A3,600W6,240W7,200W
50A6,000W10,400W12,000W

Choose the formula for your circuit

P = electrical input power in watts; I = current in amps; V = voltage in volts.
CircuitFormulaInputs
DCP = V × IDC voltage and current; power factor does not apply.
Single-phase ACP = V × I × PFRMS voltage across the load, RMS current and power factor.
Balanced three-phase ACP = √3 × V × I × PFTotal three-phase input watts, line-to-line RMS voltage and line current.

A 208V supply does not by itself tell you which mode to use. A single-phase load connected across two lines uses the single-phase formula; a balanced three-phase load uses the three-phase formula. For an unbalanced load, calculate or measure the individual phases instead.

What is power factor?

Power factor (PF) = real input power (W) ÷ apparent power (VA). It is not the motor's efficiency, which compares mechanical output with electrical input. For a consuming AC load, PF is between 0 and 1; converting positive watts to amps requires PF greater than zero.

A resistive heater can be modeled at PF = 1. Motors, compressors and electronic power supplies can have different power factors depending on the equipment and operating load. Use documented or measured input values; the calculator's default of 1 is an assumption, not a verified value for your appliance.

Use electrical input watts, not a motor's mechanical output rating. These formulas estimate operating power or current; they do not predict compressor startup surge.

A conversion is not a breaker recommendation

Calculated amps alone do not establish a safe breaker, wire size or equipment pairing. Load duration, other loads on the circuit, startup current, equipment instructions and applicable electrical requirements also matter. Check the appliance nameplate and manufacturer documentation; have circuit selection verified by a qualified electrician.

Sources and assumptions

Reference: Fluke's power factor definition and balanced three-phase power explanation. The examples on this page are calculated reference cases, not appliance measurements or installation approvals.

FAQ

How do I convert amps to watts?

Multiply amps by volts for DC. For single-phase AC, also multiply by PF. For balanced three-phase AC, multiply line current × line-to-line voltage × PF × √3 to obtain total input watts.

Does 20A at 240V always mean 4800 watts?

No. For single-phase AC, 240V × 20A is 4,800VA of apparent power. It equals 4,800W only at PF = 1. At PF = 0.8 the real input power is 3,840W.

Can I use a motor's output watts?

Use electrical input watts for these conversions. Mechanical output is lower than electrical input because of motor losses; power factor does not account for that efficiency difference.

Related tools